What the HECK is this? *Quick Pic*
#31
Driver School Candidate
Join Date: Mar 2002
Location: Pa.
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
![Thumbs up](https://www.clublexus.com/forums/images/icons/icon14.gif)
The cup holder will work in a 92 Sc400 I just did it. Also you can do it without removing any trim. All you do is drill a small hole in the blank cover plate and put in a piece of metal to pull the blank out and replace it with your new cupholder. Takes less than 5 minutes.
#33
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
Originally posted by lex400sc
The second cupholder was added in 1995. It was an option I think because I've seen them MIA in a few SCs already. If you didn't get it, you got a black plastic backpiece that clips into place. The cupholder cost something like $32 at the parts desk and is a two minute install. It sucks *** for holding tall Jack-in-the-Box type cups. They'll tip over if you take a corner too hard. It's good for 12oz soda cans and anything else that will fit in the ring *perfectly* like waxie cups.
Here's one from a Soarer...
The second cupholder was added in 1995. It was an option I think because I've seen them MIA in a few SCs already. If you didn't get it, you got a black plastic backpiece that clips into place. The cupholder cost something like $32 at the parts desk and is a two minute install. It sucks *** for holding tall Jack-in-the-Box type cups. They'll tip over if you take a corner too hard. It's good for 12oz soda cans and anything else that will fit in the ring *perfectly* like waxie cups.
Here's one from a Soarer...
#35
![Default](https://www.clublexus.com/forums/images/icons/icon1.gif)
I put a cup holder in my 93SC300. The dealer will need the VIN to match the color. I used an awl type tool (screwdriver with a threaded tip) and tapped into the back plate. I then pulled, reluctantly, and the 2 plastic tabs in the back plate gave away. The new cupholder, which has the same tabs and locations as the back plate, snapped right in. Easy job.
Thread
Thread Starter
Forum
Replies
Last Post