Hi everyone I'm new to the site.
03-29-10, 02:24 PM
#17
Driver School Candidate
Thread Starter
Join Date: Mar 2010
Location: Kentucky
Posts: 15
Likes: 0
Received 0 Likes
on
0 Posts
thanks again everyone 
I haven't really been doing much to the SC I've been busy with school and work. But here are some pic's I've got of the progress I've made with the corona over winter break
we picked up 3 engines that day for $600
We started working on the wiring harness, by pulling out all the stuff for the traction control, A/C, and some other stuff that wasn't needed
we haven't started on the one for my car yet, but here are a few pic's of the ford 8.8 we're putting in my friend's 1UZpowered AE86. But the corona is getting the same thing.
the 1uz I wanted to use came from a SC400 so the the oil sump was a rear sump, and I needed the front for my swap
here's the new FRONT sump
One of the ECU plugs were crushed on this motor when I got it so I had to replace it
I haven't really been doing much to the SC I've been busy with school and work. But here are some pic's I've got of the progress I've made with the corona over winter break
we picked up 3 engines that day for $600
We started working on the wiring harness, by pulling out all the stuff for the traction control, A/C, and some other stuff that wasn't needed
we haven't started on the one for my car yet, but here are a few pic's of the ford 8.8 we're putting in my friend's 1UZpowered AE86. But the corona is getting the same thing.
the 1uz I wanted to use came from a SC400 so the the oil sump was a rear sump, and I needed the front for my swap
here's the new FRONT sump
One of the ECU plugs were crushed on this motor when I got it so I had to replace it
Thread
Thread Starter
Forum
Replies
Last Post
