New seats in my car
03-27-10, 09:18 AM
#32
Ok ,here we go.
The pic of the front brackets. As you can see the rails are too wide. So i welded a piece of 1"x1" x 19" to bridge the rails and raise the seat 1"
Bracket from a tranny tunnel (pass)turned upside down to raise the rear.
front pass side
Rear driver side (with the rear bridge)
I did not put the bridge in the rear pass side because seat was high enough in the back....plus less work.
BTW, if you dont have a welder,heres a cheapest way to make your own, This thing works better than any cheap welders you can buy in stores. I welded everything with this home made welder, and its perfet...although not pretty
http://www.instructables.com/id/Buil...memade-Welder/
The pic of the front brackets. As you can see the rails are too wide. So i welded a piece of 1"x1" x 19" to bridge the rails and raise the seat 1"
Bracket from a tranny tunnel (pass)turned upside down to raise the rear.
front pass side
Rear driver side (with the rear bridge)
I did not put the bridge in the rear pass side because seat was high enough in the back....plus less work.
BTW, if you dont have a welder,heres a cheapest way to make your own, This thing works better than any cheap welders you can buy in stores. I welded everything with this home made welder, and its perfet...although not pretty
http://www.instructables.com/id/Buil...memade-Welder/
Thread
Thread Starter
Forum
Replies
Last Post
