oneuzfour

<object width="480" height="385"><param name="movie" value="http://www.youtube.com/v/eWMKM6wcvEo&hl=en_US&fs=1&"></param><param name="allowFullScreen" value="true"></param><param name="allowscriptaccess" value="always"></param><embed src="http://www.youtube.com/v/eWMKM6wcvEo&hl=en_US&fs=1&" type="application/x-shockwave-flash" allowscriptaccess="always" allowfullscreen="true" width="480" height="385"></embed></object>

SH_JZZ30

iTrader: (1)

Did you remove the little plastic tabs when you removed the black strip?

FuMoFFuTT

iTrader: (2)

^^ true not in the pcis

eliteskill

iTrader: (8)

Make sure you primer paint if you roll with a bat or cut with a dremel. The paint that chips off can rust and spread fast. Heat guns are awesome for this job.

1SICSC4

That guy uses a hammer. Thats just nuts.

1SICSC4

You can. I did not. Never have and probably never will. LOL. Just be careful. If you don't remove the clip you can end up with a little ripple if you are not smooth. The screws and the guard must be removed to do the roll.

abounly

iTrader: (27)

Is there a place that rents out the heat guns? Or can we simple ghetto do it even more by using a hair dryer

1JZPWRD

iTrader: (59)

Pretty good idea. Maybe the best 2.99 mod we can do..

6SOARER

iTrader: (20)

Heat guns arent expensive, I got me and my buddy one from Harbor Frieghts for $8 or $9 on sale..


I seen a guy next to my work do this.. More pics of your roll

1SICSC4

Get a heat gun. They are handy to have around. What do you want to see in the pics?

aka paco

iTrader: (15)

i wanted to try the bat method on one of my SC's, on my first SC a friend of mine had a fender roller but to my horror one of my rear fenders had some bondo work done that i didn't know about and it put a 1 and a half inch crack going upwards

i think a bat is a very good method though.

I used to always buy a heat gun at home depot or lowes and return it when i'm done, but it's so handy to have around, after a few years one time i just ended up keeping it..

abounly

iTrader: (27)

Ah i see yeah, i was searching online and its about 20-30 bucks for a heat gun. I don't see me using the heat gun more than once.

1SICSC4

Harbor freight has them for under 10 or if you are ok with some paint chips on the inside just don't use a heat gun. I guess a hair dryer would work on hi and applying heat for 15 min. LOL. Give it a shot and you will be fine. Just GO SLOW!!!

abounly

iTrader: (27)

haha alright i guess i'll buy one, so you just apply the heat gun for like 5 minutes and use something (bat) to push it in?

FuMoFFuTT

iTrader: (2)

Roll it with pressure more than push..