ArkLaTexSC

Final stages of removing the wheel hub. Two little lines are stopping me - ebrake and ABS speed sensor, I think. Unsure of how to remove those but it looks like a few bolts, I'll do it tomorrow.

bznhornets

Had the exterior detailed. Cleaned, polished, waxed and some scratches removed. Trying to get the paint to look better on all the bright sunny days we get here in the PNW. Started work on the NST short shifter install. Have to go under the car to finish disconnecting the factory shifter. The cars up on jack stands again. Also need to change the oil.

oldManTan

took off the front lip because it was completely torn into little pieces. broke like 9 of the 14 or something bolts holding it because they were all completely rusted.

also swapped the front turn signals with LEDs and got the flasher to work, no more hyperblinking and LEDs all around

Kira X

iTrader: (24)

It started raining as I pulled up to the house. I put the LS in the garage to keep it clean. I'll wash the SC tomorrow.

LEXXIUM

iTrader: (1)

After a 3 months of hybernation, battery relocation, enkei rpf1s installation and left a spare tire garage so I took her out for a ride.... I couldn't believe how light my front end and steering feels is unbelievable guys. I feel like the rear is heavier than the front, and wasn't used the the weight transformation!!! Nevertheless I had a 20 min blast today, it's just feels so awesome just driving this lexus sc400. She is dusty and dirty from sitting ...
Oh I removed the back seats too

Biddles

iTrader: (2)

Nice wheels, I saw a set on craigslist and thought about getting them, but I need to get my cash up.

mikef

iTrader: (3)

Looks good, must be fun to have a 2 car garage with a project car

LEXXIUM

iTrader: (1)

Thanks man, I had to save up for a year for those I try to work hard and be frugal with my cash, so I can have things that I like, but without Christ himself this wouldn't happen!!!!!!

Had to edit it

Qu0Cie

iTrader: (2)

Install some 5000k HID headlight/foglights.

962jzsc415

Put her on the rack to line her up. Been laggin since I replaced control arm.

Quocsc400

Got off my lazy shoe and, Wired my 92 turning lights.

Kira X

iTrader: (24)

I installed my LED brake light bulbs.

Dream36

Brake caliper bolt fell out caliper lost it when I needs to stop. Almost hit a few people. Went to parts store 1 mile away with hand brake. $20 in bolts and lube she back on road.

I blame pot holes for
2 tires "confirmed"
1 wheel "confirmed"
Wheel bearing
These bolts
Front valance decimated "confirmed"

bznhornets

Did my yearly oil change. Completed the install of the NST short shifter. I'll leave a more detailed post about this in the thread for this shifter. I haven't actually driven the car yet.

MongooseGA

iTrader: (6)

Removed and cleaned the ***** out of my throttle body.

Took my valve cover and MAF housing from looking like this:


To this:



Tomorrow is the driver's side. Should be a little bit easier.