What did you do to your SC today?
#6887
Pole Position
iTrader: (1)
Took off the 2j manifold took it to the shop to get it decked, on the way back home hit a slick spot, I spun around hit a curb took out someone's mailbox, ended up in the grass, limped home with a bent rear toe arm and who knows what else at this point, but I was lucky no one got hurt!!!
i was able to take a few pics of my 2jz nat project after I took the manifold off before I left turbo oil feed line with is300 bolt retapped and -4an clutch line
damn its sexy!!!
i was able to take a few pics of my 2jz nat project after I took the manifold off before I left turbo oil feed line with is300 bolt retapped and -4an clutch line
damn its sexy!!!
#6891
Pole Position
iTrader: (1)
Took off the 2j manifold took it to the shop to get it decked, on the way back home hit a slick spot, I spun around hit a curb took out someone's mailbox, ended up in the grass, limped home with a bent rear toe arm and who knows what else at this point, but I was lucky no one got hurt!!!
i was able to take a few pics of my 2jz nat project after I took the manifold off before I left turbo oil feed line with is300 bolt retapped and -4an clutch line
damn its sexy!!!
i was able to take a few pics of my 2jz nat project after I took the manifold off before I left turbo oil feed line with is300 bolt retapped and -4an clutch line
damn its sexy!!!
GO NA-t!!!
#6895
Pole Position
iTrader: (7)
SC400 Manual Swap
I got a lot done today on my manual swap project.
Awaiting the swap.
Interior removed for an easier install. Also installing a Supra TT fuel pump
Manual brake pedal installed.
Ready for transmission to be dropped
2 of 3 holes drilled. Didn't have the holesaw size on me
Awaiting the swap.
Interior removed for an easier install. Also installing a Supra TT fuel pump
Manual brake pedal installed.
Ready for transmission to be dropped
2 of 3 holes drilled. Didn't have the holesaw size on me
The following users liked this post:
Kira X (10-10-17)
#6900
Pole Position
iTrader: (7)
[QUOTE=Blkexcoupe;10001046]You need to make a dedicated build thread for your SC's. I may have missed it, but which transmission are you going with?
I really do. I have the pics, just need to get the threads going. I’m going with the W58 since I got such a great deal on the swap with the tranny included. I will also have a spare W58 from my SC300. 6 speed(T56 Magnum) going in the SC300 with the built motor - 1000WHP goal with the help of Gerry
Last edited by JasGS350; 10-09-17 at 11:57 AM.