What did you do to your SC today?
#8041
Driver School Candidate
Join Date: Jun 2014
Location: New Jersey
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Putting some time into her:
Love my baby, but she needs some love. I’m going to get some quotes for her interior refresh from a couple local auto interior specialists. My door panels are garbage.
The following users liked this post:
Accord-R (05-14-21)
#8043
Advanced
As much as I have done to my car, I have never posted here, so I will start with yesterday. I installed a Supra HKS mid pipe which now I am a little louder with the already installed Manzo stainless rear mufflers. No drone and I love it. Will get used to it before I install headers.
I had to remove my air dam / splitter from the front because it was dragging so much since I had lowered it with Supra lowering springs and KYB gas Adjust shocks /struts.
Not sure what is next but probably new bushings in the diff.
I had to remove my air dam / splitter from the front because it was dragging so much since I had lowered it with Supra lowering springs and KYB gas Adjust shocks /struts.
Not sure what is next but probably new bushings in the diff.
The following users liked this post:
RudysSC (05-12-21)
#8044
Got some gauges and a gauge cluster. These are the Banks iDash. Each gauge can display up to 8 parameters and has programmable functions like a shift light and warning for limits. I am connecting this to the CAN bus on the Haltech, but they also work off of OBD2. THe price is not much more than a good analog gauge as well, plus they have external sensors you can wire in to the display.
#8045
Driver School Candidate
a lot of plastic jb weld!
so i figured that we all have this common issue of the upper interior window wraparound, or whatever is the correct term for it is, breaking in the middle. when i unbolted it i noticed how tight that area is cause there is a bolt right before where all of our frame snaps. common issues always have a underlaying trigger and that was it so i decided to relax that area and give the frame a little gap. i took the leather off and used tape to line up the upper part with a small gap. turned it around and plastic weld the heck outa it. its on its way to the upholstry shop who will re wrap the leather. ill keep yall posted on the fitment.
The following users liked this post:
Accord-R (05-14-21)
The following 2 users liked this post by Accord-R:
Bimmerbill (05-17-21),
RudysSC (05-18-21)
The following users liked this post:
Barbary (05-24-21)
The following users liked this post:
Duck05 (05-25-21)
The following users liked this post:
Kira X (05-29-21)
#8054
Pole Position
Love the white housings - I'd love to see a photo of those on the car!
The following 2 users liked this post by RudysSC:
Bimmerbill (05-25-21),
sc300nah (05-28-21)