My Front-Lip Scrape Guard from Home Depot, Using Industrial Strength Velcro
#19
It was okay in practice as it posed 2 problems:
1. The SC's bumper scrapes at the front edge and velcro does not extend past the edge
2. The adhesive is super strong and tears off the paint when I repainted the bumper.
I will make a post of what I did that works 100000x better
1. The SC's bumper scrapes at the front edge and velcro does not extend past the edge
2. The adhesive is super strong and tears off the paint when I repainted the bumper.
I will make a post of what I did that works 100000x better
#21
Lexus Test Driver
So hows that metal scrape guard working out for you man? I would consider it, bu I'm worried about the bolts that keep it on (Looks like you scrape that more, shouldn't you get a flatter set of bolts?).
#22
Pole Position
decent idea! however wont work for the application for the lip im looking at. to protect it im more then likely going to use sheet metal, and make skid plate. also more then likely going to use rivets, and bolts in the wheels wells.
Thread
Thread Starter
Forum
Replies
Last Post
handoverfi
GS - 2nd Gen (1998-2005)
8
12-07-08 02:09 PM