2011 project done.. for now
#48
Lead Lap
Thread Starter
iTrader: (6)
Join Date: Aug 2010
Location: CA
Posts: 434
Likes: 0
Received 0 Likes
on
0 Posts
Car is at my buddys shop right now getting a ffim fabbed up then all my new stuff is going to go in, trying to gather up parts to get my r154 rebuilt... Duno if that w58 is going to be ok or not lol
#49
Lead Lap
Thread Starter
iTrader: (6)
Join Date: Aug 2010
Location: CA
Posts: 434
Likes: 0
Received 0 Likes
on
0 Posts
UPDATES:
R154 in had some issues with the drive line by adding just the front half of the 1jz it was still 1/2 inch too long had to take it to a local driveline place and had it cut down and rebalanced. and the swan shifter from my r154 and w58 were different the one from my old w58 fit alot better
so far the HPF bronze clutch feels pretty good so far a bit heavier then stock on the pedal but not by much and very streetable, very quiet for a 6puck and with a hp rating of 650 it should be fine for along time with future upgrades!
just got the new VC installed today
and this weekend!
brand new Powerslot rotors and freshly rebuilt ls4 calipers + polish
R154 in had some issues with the drive line by adding just the front half of the 1jz it was still 1/2 inch too long had to take it to a local driveline place and had it cut down and rebalanced. and the swan shifter from my r154 and w58 were different the one from my old w58 fit alot better
so far the HPF bronze clutch feels pretty good so far a bit heavier then stock on the pedal but not by much and very streetable, very quiet for a 6puck and with a hp rating of 650 it should be fine for along time with future upgrades!
just got the new VC installed today
and this weekend!
brand new Powerslot rotors and freshly rebuilt ls4 calipers + polish
Last edited by broda805; 06-23-11 at 09:45 PM.