Gauging Interested for Vented Fiberglass or CF Hood Group Buy
09-13-02, 03:55 AM
#47
I think the Veilside hood has too many vents in it and would require a "veilside" bodykit to match the hood.
Now that i've acquired a new project, I think i'll be in need for a good vented cf hood. I'll be one of those who will jump in probably if it's finalized!
Gotta check with another source first before I commit to anything.
Tony
Now that i've acquired a new project, I think i'll be in need for a good vented cf hood. I'll be one of those who will jump in probably if it's finalized!
Gotta check with another source first before I commit to anything.
Tony
09-13-02, 12:57 PM
#51
Driver
Thread Starter
Join Date: Sep 2001
Location: Maryland
Posts: 180
Likes: 0
Received 0 Likes
on
0 Posts
We’ll have to go with the style of vents that has the most buyers. I thought we were ready to start the GB but there must be a definite design when it goes official. Personally, I’ll have ground effects to go with mine so either would be nice. I’ll leave the finial say to you guys.
VeilsideRSPsc yes the carbon fiber coated, like the fiberglass, does NOT require hood pins. The carbon fiber is also guaranteed against any flaw or defect in the carbon fiber skin itself. In fact, if they would make a slight mistake in the pattern when laying the skin on one of them, anyone who would want it would get it VERY cheap!
VeilsideRSPsc yes the carbon fiber coated, like the fiberglass, does NOT require hood pins. The carbon fiber is also guaranteed against any flaw or defect in the carbon fiber skin itself. In fact, if they would make a slight mistake in the pattern when laying the skin on one of them, anyone who would want it would get it VERY cheap!
09-13-02, 01:26 PM
#54
Driver
Thread Starter
Join Date: Sep 2001
Location: Maryland
Posts: 180
Likes: 0
Received 0 Likes
on
0 Posts
A pic of the veilside in black. Remember, ours would include the same lines one the sides of the vent which we have now.
Also I thanks for the encouraging comments from those who are ready to pay now! But the GB will be official before any money can be accepted.
Also I thanks for the encouraging comments from those who are ready to pay now! But the GB will be official before any money can be accepted.
09-15-02, 03:23 AM
#58
Rookie
Join Date: Nov 2001
Location: Alabama
Posts: 66
Likes: 0
Received 0 Likes
on
0 Posts
Im in....
Im in for a Grade A Veilside style CF hood.
(similar to pic attached)
I also like the Aerogear Predator hood..
If this gets off the ground let me know.
I was using VIS racing for the manufacturer, there stuff
has done well with me in the past.
I have talked to another source last week and trying to
get something going there too.
The T&E hood is available from Japan if you want the OEM look.
(similar to pic attached)
I also like the Aerogear Predator hood..
If this gets off the ground let me know.
I was using VIS racing for the manufacturer, there stuff
has done well with me in the past.
I have talked to another source last week and trying to
get something going there too.
The T&E hood is available from Japan if you want the OEM look.
Last edited by Soarer007; 09-15-02 at 03:24 AM.
Whatever style so long as it has a vent. And I actually think I'll get the CF covered fiberglass one now.