NA-T throttle body question
#1
Pole Position
Thread Starter
NA-T throttle body question
i modified a gte intake to fit my GE if i removed the two sub-throttle actuators, will that effect anything?
im trying to clean up the stock throttle body and have less wiring
im trying to clean up the stock throttle body and have less wiring
#2
Lexus Champion
iTrader: (10)
yes, its a common modification, just unbolt what you can, then most people grind down the extra parts and have the small holes welded shut. Some people even enlarge the hole on the sub throttle actuator side, and weld a BOV flange to it (most common i have seen on supras are the tial because they fit easily and are roundish).
you will have to jumper the sub throttle tps pin at the ecu to get rid of the CEL if you are on the stock ecu.
I believe it is jumpered to sensor 5v, so that the ecu thinks its always WOT.
you will have to jumper the sub throttle tps pin at the ecu to get rid of the CEL if you are on the stock ecu.
I believe it is jumpered to sensor 5v, so that the ecu thinks its always WOT.
#5
Lexus Champion
iTrader: (10)
this is a good example from this thread
http://www.supraforums.com/forum/sho...=1#post7233420
there are some companies that will even perform the modification for you.
http://www.suprastore.com/hksssbovcusi.html
http://www.supraforums.com/forum/sho...=1#post7233420
there are some companies that will even perform the modification for you.
http://www.suprastore.com/hksssbovcusi.html
Last edited by Ali SC3; 05-21-12 at 08:20 AM.
Thread
Thread Starter
Forum
Replies
Last Post
snomanlex
SC400 / 300 Classifieds
12
10-15-11 07:51 PM