1st Thing You Did When..
06-11-12 | 01:43 PM
#31
Thread Starter
Driver
Joined: Jun 2012
Posts: 120
Likes: 3
From: Ca
Got my SC400 from a member here who often ran triple digit speeds with..... I rebuilt both front hubs, 1 caliper, new rotors and pads for all 4 corners, new struts all around, complete tune-up, new tires. Recently (last 2 months) rebuilt LCA's, tie rods, good alignment, new factory black paint, re-ferbed the wheels, tint.
Car looks amazing for being a '93'....and only 102k miles., maybe post some pictures next week. Still need to do water pump / timing belt mx.
Car looks amazing for being a '93'....and only 102k miles., maybe post some pictures next week. Still need to do water pump / timing belt mx.
06-11-12 | 04:04 PM
#34
Rookie
Joined: May 2012
Posts: 96
Likes: 1
From: MD
put a new head unit, amp, subs, and battery. Should have made sure everything under the hood was good instead, since my o-ring leak ended up killing my alternator and my power steering leak killed my steering rack bushings.
06-11-12 | 07:11 PM
#35
Thread Starter
Driver
Joined: Jun 2012
Posts: 120
Likes: 3
From: Ca
can i throw HID's in the Fog Lights? i wanted to throw some 6k's in the fogs and have reg lights so i can turn on the fogs only when i want...
06-13-12 | 12:18 AM
#42
Well let's see.
The 98 SC300 I drove it straight to the shop to have the valve cover gaskets and rear main seal replaced.
The 2000 SC300 I drove it straight to the same shop for the timing belt.
The 92 SC400 I currently drive now I put my TT's on it. Same wheels I've had on all three.
The 98 SC300 I drove it straight to the shop to have the valve cover gaskets and rear main seal replaced.
The 2000 SC300 I drove it straight to the same shop for the timing belt.
The 92 SC400 I currently drive now I put my TT's on it. Same wheels I've had on all three.
06-13-12 | 01:09 AM
#43
Pole Position
Joined: Apr 2012
Posts: 387
Likes: 0
From: CA
well bought my SC for 1400 needed and needs a lot of work.
so far ive, replaced the sound system, fixed/aligned the trunk (wouldnt open due to broken latch, lock cylinder, and out of alignment), replaced sparkplugs, wireset, distributor cap and rotor, new valve cover gasket, new TBI gasket, new wheel locks bcuz the lug nuts where mismatched, etc. lol. my cars a mean project. not running at the moment due to some vacuum hoses that broke during the valve cover gasket fix. ima fix this tomorrow hopefully and yes im taking loads of pics -__-
so far ive, replaced the sound system, fixed/aligned the trunk (wouldnt open due to broken latch, lock cylinder, and out of alignment), replaced sparkplugs, wireset, distributor cap and rotor, new valve cover gasket, new TBI gasket, new wheel locks bcuz the lug nuts where mismatched, etc. lol. my cars a mean project. not running at the moment due to some vacuum hoses that broke during the valve cover gasket fix. ima fix this tomorrow hopefully and yes im taking loads of pics -__-
