Have a sc400 dropped it and now my engine harness is exposing
#16
@ conwest that looks way more easier omfg my wires r worst im talking bout it chewed thru everthing so i have to wrap each wire back and look for any damage wires and put them back but thanks this looks way more easier
#18
Like many others, I pulled the harness and airbag wires higher up in both fenders
I wrapped the hell out of it with five layers of electrical tape and drilled a few more holes to secure zip-ties to pull it even higher up.
The wires are all well away from any tire contact points. It was a twenty minute job. Gives an other 1/2" of clearance if done on the passenger side as well.
I wrapped the hell out of it with five layers of electrical tape and drilled a few more holes to secure zip-ties to pull it even higher up.
The wires are all well away from any tire contact points. It was a twenty minute job. Gives an other 1/2" of clearance if done on the passenger side as well.
Thread
Thread Starter
Forum
Replies
Last Post
esco2114
SC- 1st Gen (1992-2000)
4
04-20-11 11:02 PM