WTB: AEM EMS for 2jzge na application 1101 and all sensors
#1
Pole Position
Thread Starter
iTrader: (1)
Join Date: Jan 2008
Location: CA
Posts: 387
Likes: 0
Received 0 Likes
on
0 Posts
WTB: AEM EMS for 2jzge na application 1101 and all sensors
Hey, so i was planning on purchasing a full aem setup from a guy that included the aem ems (1101) a 5.0 bar map sensor, an IAT sensor and an aem uego wideband, however he just today decided to keep it all until after TX2K9, (AGGG) and i'm trying to make a tune in socal in mid february so i need these parts quick.
The parts i need once again are
1. Aem Ems for sc300 or na supra application (# 1101)
2. Map bar sensor, idealy a 3.5 bar, but anything above will work.
3. IAT (incoming air temp sensor)
4. Aem Uego wideband.
I would like do get all these parts in one run but i know i most likely won't be lucky enough to have that opportunity again any time soon. Seriously i am in a huge rush. So let me know if you've got any of this stuff.
Thanks guys.
You can contact me via email at Dxyz3@aol.com or just pm here on the forums.
-David
The parts i need once again are
1. Aem Ems for sc300 or na supra application (# 1101)
2. Map bar sensor, idealy a 3.5 bar, but anything above will work.
3. IAT (incoming air temp sensor)
4. Aem Uego wideband.
I would like do get all these parts in one run but i know i most likely won't be lucky enough to have that opportunity again any time soon. Seriously i am in a huge rush. So let me know if you've got any of this stuff.
Thanks guys.
You can contact me via email at Dxyz3@aol.com or just pm here on the forums.
-David
Thread
Thread Starter
Forum
Replies
Last Post