FS: Rotora Blue 6 Pot BBK // Work VS-XX 19x9 and 19x10 // HKS HyperMax III's
03-30-09 | 12:27 AM
#18
Thread Starter
Driver School Candidate
Joined: Apr 2006
Posts: 47
Likes: 0
From: CA
Please excuse the pictures...I was in a hurry to get something up so you guys can see...
The wheels are just dirty..But will clean up nicely.
Let me know...Pics of the seats and brackets will be up shortly..
Also I have added Ichiba 5mm Spacers and 4 Point Takatas both Short and Long Versions.
The wheels are just dirty..But will clean up nicely.
Let me know...Pics of the seats and brackets will be up shortly..
Also I have added Ichiba 5mm Spacers and 4 Point Takatas both Short and Long Versions.
Last edited by MrWong; 03-30-09 at 12:32 AM.
03-30-09 | 12:28 AM
#19
Thread Starter
Driver School Candidate
Joined: Apr 2006
Posts: 47
Likes: 0
From: CA
Blkexcoupe - Yup it's Me Still got the 5th gen too = )
The wheels are BBK Compatible up to 4 Piston. My 6 Pot Rotoras need a 5mm Spacer to clear up in front.
The BBK is 6 Pot Front only.
Only 1 Torino is available.
As far as changing the bracket I am not 100% sure..I'm sure Rotora can give you an answer.
Rolling fender is not needed unless your super low then I don't know.
I ran a 5mm Spacer up Front and 10mm Spacer in the Rear. I mounted these once before getting spacers. So I couldn't really tell you. I shaved my Front and Rear fenders so I'm not sure. Sorry
Thanks guys...
-Henry
The wheels are BBK Compatible up to 4 Piston. My 6 Pot Rotoras need a 5mm Spacer to clear up in front.
The BBK is 6 Pot Front only.
Only 1 Torino is available.
As far as changing the bracket I am not 100% sure..I'm sure Rotora can give you an answer.
Rolling fender is not needed unless your super low then I don't know.
I ran a 5mm Spacer up Front and 10mm Spacer in the Rear. I mounted these once before getting spacers. So I couldn't really tell you. I shaved my Front and Rear fenders so I'm not sure. Sorry
Thanks guys...
-Henry
Last edited by MrWong; 03-30-09 at 12:39 AM.
