IL AEM EMS, BL Pipes, AUTO TT LSD, Lots of Parts!
11-14-09, 08:27 AM
#1
Lead Lap
Thread Starter
iTrader: (3)
Join Date: Mar 2004
Location: Illinois
Posts: 491
Likes: 0
Received 0 Likes
on
0 Posts
AEM EMS, BL Pipes, AUTO TT LSD, Lots of Parts!
Going a new direction with the build. All prices OBO. Lets make a deal
AEM EMS with 3.5 bar map sensor and IAT sensor..................SOLD
Auto TT LSD...................................................................$900
Boostlogic Intercooler Piping w/coupler and clamps..................$300
Greddy RS bov flange already welded on. One pipe has a very tiny hole (common area where pipe rubs against the sway bar). You can put a coupler over it to bandage it.
Brand New 2JZGE Gasket/Seals Set w/1.3mm HG (all seals and gaskets)....$225
Godspeed Intercooler - black some paint chipping off, no leaks.....$50
27.5" end tank to tank, 9.5" top to bottom, 2.75" width, 2.5" inlet/outlet diameter
Apexi AVCR Boost Controller with harness/sensors, etc..............SOLD
Brand New Fidanza Light Weight Flywheel (W58)......................$350
6 NA stock injectors......................................... ...................$40
IACV.............................................. ..................................SOLD
SC300 Driver Side Head Light............................................. ...$50
Manual Transmission ECU......................................................$50
Tan Upper Radio Trim with all buttons and cupholders...............$100
AEM EMS with 3.5 bar map sensor and IAT sensor..................SOLD
Auto TT LSD...................................................................$900
Boostlogic Intercooler Piping w/coupler and clamps..................$300
Greddy RS bov flange already welded on. One pipe has a very tiny hole (common area where pipe rubs against the sway bar). You can put a coupler over it to bandage it.
Brand New 2JZGE Gasket/Seals Set w/1.3mm HG (all seals and gaskets)....$225
Godspeed Intercooler - black some paint chipping off, no leaks.....$50
27.5" end tank to tank, 9.5" top to bottom, 2.75" width, 2.5" inlet/outlet diameter
Apexi AVCR Boost Controller with harness/sensors, etc..............SOLD
Brand New Fidanza Light Weight Flywheel (W58)......................$350
6 NA stock injectors......................................... ...................$40
IACV.............................................. ..................................SOLD
SC300 Driver Side Head Light............................................. ...$50
Manual Transmission ECU......................................................$50
Tan Upper Radio Trim with all buttons and cupholders...............$100
Last edited by chitwnsazn; 12-15-09 at 07:32 PM.
11-14-09, 12:49 PM
#5
Lead Lap
Thread Starter
iTrader: (3)
Join Date: Mar 2004
Location: Illinois
Posts: 491
Likes: 0
Received 0 Likes
on
0 Posts
I'll have to take some measurements but from what I remember it's 2.5in inlet/outlets. Piping is from boostlogic NA-T kit, can be viewed at boostlogic.com. It can pretty much be made to fit a variety of set ups. I did not use it with boostlogic's turbo kit and didn't have to do any cutting at all except for the BOV flange.
Trending Topics
11-19-09, 04:59 AM
#13