NH MOTEC M48 Engine management with Full Harness and Extras
#1
Pole Position
Thread Starter
Join Date: Feb 2007
Location: NH
Posts: 224
Likes: 0
Received 0 Likes
on
0 Posts
MOTEC M48 Engine management with Full Harness and Extras
Nazar
603-489-9859
Location: Atkinson NH
Pick up welcome.
MOTEC M48 Engine management with Full Harness
Extra options, Wide band lambda2, Air Intake Temp, 2 X Map Senors.
Also comes with full Injector Harness. and Other sensor harnesses.
All cables are and were tagged when taking out. In excellent condition.
The car ran and drove before it was taken out.
It was tuned for a GT4094
It was installed in a 95 Na-T with Distributor.
Willwork with TT motor and distributorless set up.
Will come with MSD6AL and a Coil.
Took it out of the car.
Used for less the 500 miles (I was told)
Software can be downloaded.
If you are looking for an AEM Stand alone this maybe a higher end option.
This ECU will work with 4/6/8 cylnder configurations.
Click below for Full details of this set up.
This ecu sells for about $2700
+ about $1000 Wiring harness
+ Msd6al $200
+ Coil $100
+ Map sensors $150 each X2
+ Air intake temp $35
Total Value over $4200
Sell for $2300 For everything.
http://www.motec.com.au/m48/m48overview/
603-489-9859
Location: Atkinson NH
Pick up welcome.
MOTEC M48 Engine management with Full Harness
Extra options, Wide band lambda2, Air Intake Temp, 2 X Map Senors.
Also comes with full Injector Harness. and Other sensor harnesses.
All cables are and were tagged when taking out. In excellent condition.
The car ran and drove before it was taken out.
It was tuned for a GT4094
It was installed in a 95 Na-T with Distributor.
Willwork with TT motor and distributorless set up.
Will come with MSD6AL and a Coil.
Took it out of the car.
Used for less the 500 miles (I was told)
Software can be downloaded.
If you are looking for an AEM Stand alone this maybe a higher end option.
This ECU will work with 4/6/8 cylnder configurations.
Click below for Full details of this set up.
This ecu sells for about $2700
+ about $1000 Wiring harness
+ Msd6al $200
+ Coil $100
+ Map sensors $150 each X2
+ Air intake temp $35
Total Value over $4200
Sell for $2300 For everything.
http://www.motec.com.au/m48/m48overview/
Last edited by Nazar; 08-04-10 at 06:59 AM.
Thread
Thread Starter
Forum
Replies
Last Post
jwin
SC400 / 300 Classifieds
2
02-03-14 08:48 PM