Guys, I have a few pairs of these exhaust tips for sale for the SC400/SC300 and GS300/GS400.

They are oval in shape and much better than stock OEM tips. They are much classier looking and have more of a presence. You will definitely get tons of compliments.

A nicer, cheaper and quieter alternative vs. getting an aftermarket exhaust.

Made of high quality T-304 stainless steel so it will never rust or discolor.

Prices INCLUDING shipping is $60 for 1 tip or $110 for 2 tips.

 

Here is a picture of them on my car

 

i have a question before deciding. i looked at my stock tips.... how can i remove that? or i have to go to a body shop to un-weld the stock ones and put on the new ones?

 

I just had them cut mine off. Don't know if you want to do that though. It was fast and easy. Took them about 5 min. to install both tips.

 

Hey guys,

The stock tips need to be banged out with a rubber mallet slowly. They will jar lose and then you just pull them off. After you remove the gs tips, clean the pipes and remove any surface residue and carbon deposits. Than, I would take the car and tips to an exhaust guy, I used local midas near my house. Tell them you want to tac weld these tips into place. A tac weld, is basically melting down a copper wire with a electric current. Do one or two welds to hold it in place then center it within the cavity, and have them finish the tac welding to secure it. Cost was $20 for both tips. These tips fit perfectly within the cavity of the GS and SC models. Also, looks really nice on ES 97-03 models.

McGong how are the tips holding up on your car? Have you received a lot of compliments on them?

 

Are those the same Borla tips you were selling a while back? Will they fit a first gen gs300 OK? I might take a set. PM me. Thanks.

Minh

 

Yes, they will also fit the 1 gen GS