NC WTB ASAP!! Lower control arm, good or bad!!!
#1
WTB ASAP!! Lower control arm, good or bad!!!
My dumb, overzealous, self destroyed the aluminum sleeve that goes in the front lower control arm bushing.
I saw the sleeves in the bushing kit and assumed they replaced the stock inner sleeves, but apparently not. Anywho, I REALLY need this bushing asap so I can get my car back together and aligned!
Anyone replace their LCAs and have a junk one lying around?
You can send me the whole arm, or just punch the insert out and mail me that, whichever you prefer.
Again, I need the aluminum one, not the steel one. I managed to not trash the steel one, so this one little piece is all I need to finish this job
Help me out CL brethren!!
I saw the sleeves in the bushing kit and assumed they replaced the stock inner sleeves, but apparently not. Anywho, I REALLY need this bushing asap so I can get my car back together and aligned!
Anyone replace their LCAs and have a junk one lying around?
You can send me the whole arm, or just punch the insert out and mail me that, whichever you prefer.
Again, I need the aluminum one, not the steel one. I managed to not trash the steel one, so this one little piece is all I need to finish this job
Help me out CL brethren!!
#2
Lexus Champion
iTrader: (21)
You could just make one. Go to a metal shop like metalsupermarkets.com & have them cut off a chunk of round stock & take it to someone that has a drill press & have them drill out the center. probably cost you $20.00 total. If my buddy still has the supra ones that i pressed out of my brand new supra LCA, ill hit you back. GL.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post
RedPhoenix
SC400 / 300 Classifieds
1
03-27-09 01:21 PM