FS: Doluck Rear Wing & Floor Support Bars
#1
Lead Lap
Thread Starter
Join Date: Feb 2002
Location: California
Posts: 774
Likes: 0
Received 0 Likes
on
0 Posts
FS: Doluck Floor Support Bars
Alright I'm selling the last two things I have.
Do-Luck Floor Support Bars (Steel) $260 Plus Shipping.
Do-Luck Floor Support Bars
Just thought I'd add this in. I will not take measurements for the support bars since a few have asked for them. Buy the bars they are decently priced.
Do-Luck Floor Support Bars (Steel) $260 Plus Shipping.
Do-Luck Floor Support Bars
Just thought I'd add this in. I will not take measurements for the support bars since a few have asked for them. Buy the bars they are decently priced.
Last edited by TurboB6; 02-07-03 at 06:39 PM.
Trending Topics
#8
Lead Lap
Thread Starter
Join Date: Feb 2002
Location: California
Posts: 774
Likes: 0
Received 0 Likes
on
0 Posts
ttt
everyone is always talking about getting japanese stuff then when the time comes no one steps up, whats up with that?
everyone is always talking about getting japanese stuff then when the time comes no one steps up, whats up with that?
Last edited by TurboB6; 01-16-03 at 12:56 AM.
#11
Lead Lap
Thread Starter
Join Date: Feb 2002
Location: California
Posts: 774
Likes: 0
Received 0 Likes
on
0 Posts
Prevents chassis flex. It goes under the car next to the pinch welds (basically runs from little bit before the rear wheel to little bit before the front wheel).
Last edited by TurboB6; 01-20-03 at 02:32 AM.
#12
Lexus Test Driver
ahh I found out from the do-luck usa site
"Floor Support Bar
This application is designed to stiffen the chassis for front to back movement. While strut bars stiffen the chassis for left to right movement the Floor Support Bars assist with stiffen the chassis for hard acceleration and braking."
"Floor Support Bar
This application is designed to stiffen the chassis for front to back movement. While strut bars stiffen the chassis for left to right movement the Floor Support Bars assist with stiffen the chassis for hard acceleration and braking."