Yes

you can't go wrong with brembo. just make sure your offsets allow enough room for your wheels to clear it. like the name say, it's a big brake kit.

i2fat

iTrader: (2)

Anyone have pictures of SC430s with 20s and not lowered? Or someone with nice 18s and not lowered?

Yes

before



after



the biggest difference is the rear. you have a huge gap if you don't lower it.

i2fat

iTrader: (2)

Thanks. Yeah the gap is big

i2fat

iTrader: (2)

What do you guys think on a Black/Black car?

20x8.5 F and 20x10 R

i2fat

iTrader: (2)

Posted this in the Wheel Alignment thread as well.. "Ok, so I'm way new at this and was wondering if.. these will fit. According to the chart that Rominl posted it will, but I just wanted to know if it will sit close to "flush"? (I'm assuming that flush means everything lines up)

20 X 8.5 +20

20 X 10 + 25

Thanks for bearing with me lol."

Yes

those should fit fairly flush. you'll probably have some rubbing going over bumps. but the tires will wear through the liner and it'll be fine.

i2fat

iTrader: (2)

Thanks Liquid. Will probably get those wheels and lower my car.

Yes

no problem. just so you know, that is a fairly aggressive fitment, so you might run into rubbing issues. worst case scenario, you have to roll your fenders. i don't think you'll have to, but it's possible.

i2fat

iTrader: (2)

Is fender rolling a pretty task to do? I really didn't want to do anything after lowering the car. Hmm hope it doesn't rub.

Yes

I've never done it, so I don't know for sure. I've heard it's not too difficult, but I personally wouldn't want to do it. You could go a little more conservative on the offsets if you're worried about it.

i2fat

iTrader: (2)

Unfortunately the next available offset would be +40 and I would probably need to buy spacers. :/