Rear trunk struts
#16
Interesting the following instructions say different.[ came off ebay lift support depot site ]
Remove the old support from the vehicle by placing a small flat headed screw driver under the U shaped band on the ends of the support. Slowly turn the screw driver and it will lift up on the band approx.1/8", then pull the support away from the vehicle and it will release.
To install the new supports do the same procedure in reverse. DO NOT jam the new support end over the ball socket without lifting the U band slightly or damage may occur.
So who is right
Remove the old support from the vehicle by placing a small flat headed screw driver under the U shaped band on the ends of the support. Slowly turn the screw driver and it will lift up on the band approx.1/8", then pull the support away from the vehicle and it will release.
To install the new supports do the same procedure in reverse. DO NOT jam the new support end over the ball socket without lifting the U band slightly or damage may occur.
So who is right
#18
trunk struts
My question is after you put in new struts when you unlock the trunk with either the remote or button in the car should the trunk lid pop up or do you have to lift it up to access the trunk area.Most cars after up unlock the trunk the lid pops up a little to get your hand under the trunk lid.Thanks Jimbo
#19
Interesting the following instructions say different.[ came off ebay lift support depot site ]
Remove the old support from the vehicle by placing a small flat headed screw driver under the U shaped band on the ends of the support. Slowly turn the screw driver and it will lift up on the band approx.1/8", then pull the support away from the vehicle and it will release.
To install the new supports do the same procedure in reverse. DO NOT jam the new support end over the ball socket without lifting the U band slightly or damage may occur.
So who is right
Remove the old support from the vehicle by placing a small flat headed screw driver under the U shaped band on the ends of the support. Slowly turn the screw driver and it will lift up on the band approx.1/8", then pull the support away from the vehicle and it will release.
To install the new supports do the same procedure in reverse. DO NOT jam the new support end over the ball socket without lifting the U band slightly or damage may occur.
So who is right
#20
My question is after you put in new struts when you unlock the trunk with either the remote or button in the car should the trunk lid pop up or do you have to lift it up to access the trunk area.Most cars after up unlock the trunk the lid pops up a little to get your hand under the trunk lid.Thanks Jimbo
#21
My question is after you put in new struts when you unlock the trunk with either the remote or button in the car should the trunk lid pop up or do you have to lift it up to access the trunk area.Most cars after up unlock the trunk the lid pops up a little to get your hand under the trunk lid.Thanks Jimbo
#23
Thread
Thread Starter
Forum
Replies
Last Post
NovaRnder
SC430 - 2nd Gen (2001-2010)
11
01-06-15 11:43 AM