Custom Face Plate
#1
Driver School Candidate
Thread Starter
Custom Face Plate
I recently installed a Pioneer AVH4500NEX in my 2003 SC430. I used a Beatsonic interface due to the benefits derived from the integration with the NAV/Steering wheel controls. The Beatsonic kit also includes some snap on face plates that locate on each side of the radio. The problem is the gap at the top of the radio. Does anyone know a way to fill this gap? What material I could use to fabricate something? Ideas on how to keep it in place? Here are some photos. Any advice is appreciated!
Last edited by jmjsc430; 04-28-20 at 01:14 PM.
#4
I sourced an aftermarket plastic full frame to replace the beatsonic add on pieces. $45 on eBay? Painted silver is a fair match to the rest of the dash.
here is the link
https://www.ebay.com/itm/Metra-99-81...-/311602525569
here is the link
https://www.ebay.com/itm/Metra-99-81...-/311602525569
Last edited by Caflashbob; 04-28-20 at 08:06 PM.
#5
Driver School Candidate
Thread Starter
I sourced an aftermarket plastic full frame to replace the beatsonic add on pieces. $45 on eBay? Painted silver is a fair match to the rest of the dash.
here is the link
https://www.ebay.com/itm/Metra-99-81...-/311602525569
here is the link
https://www.ebay.com/itm/Metra-99-81...-/311602525569
#6
Thread
Thread Starter
Forum
Replies
Last Post
alexmoore
SC430 - 2nd Gen (2001-2010)
7
03-23-15 12:47 PM