Updating my steering wheel I want your feedback
#1
Pole Position
Thread Starter
Updating my steering wheel I want your feedback
I've already done an is swap, but at that time I wasnt sure if it was going to work so i purchased a used wheel. Well now the leather is starting to show wear, so its time for an upgraded this is what I've been looking at
#3
Pole Position
Thread Starter
#4
btw, I noticed you have that Tesla style unit too....
#6
Lead Lap
#7
Pole Position
Thread Starter
I would go with any of the flat bottom designs. But how would you get your hands on one of these babies? Savage yards? Knock-off Chinese models? And how would it affect the existing airbag mechanics? What are the costs involved? I’m very interested in this mod.
btw, I noticed you have that Tesla style unit too....
If I recall, I paid about 150$ for the wheel 175$ for the airbag and 35$ to get the correct buttons. All parts used from EBay. I was trying to keep cost down as much as possible since I wasn entirely sure it would work. Then I did all the wiring and install myself.
Trending Topics
#8
saw that one huh? 😉😎
If I recall, I paid about 150$ for the wheel 175$ for the airbag and 35$ to get the correct buttons. All parts used from EBay. I was trying to keep cost down as much as possible since I wasn entirely sure it would work. Then I did all the wiring and install myself.
If I recall, I paid about 150$ for the wheel 175$ for the airbag and 35$ to get the correct buttons. All parts used from EBay. I was trying to keep cost down as much as possible since I wasn entirely sure it would work. Then I did all the wiring and install myself.
#9
Driver School Candidate
saw that one huh? 😉😎
If I recall, I paid about 150$ for the wheel 175$ for the airbag and 35$ to get the correct buttons. All parts used from EBay. I was trying to keep cost down as much as possible since I wasn entirely sure it would work. Then I did all the wiring and install myself.
If I recall, I paid about 150$ for the wheel 175$ for the airbag and 35$ to get the correct buttons. All parts used from EBay. I was trying to keep cost down as much as possible since I wasn entirely sure it would work. Then I did all the wiring and install myself.
#12
Pole Position
Thread Starter
#13
Pole Position
Thread Starter
Last edited by sprtn131; 07-22-18 at 06:47 PM.
Thread
Thread Starter
Forum
Replies
Last Post
xspsi6
SC- 1st Gen (1992-2000)
11
03-06-11 06:46 PM