CatManD3W SC300 Ongoing Build...
01-12-17, 11:35 AM
#901
Added some new Sparco touches to the car........if you ask why "cuz racecar"
I will show more detailed pics when I get both of them installed and document the process. But for right now it is just mocked up.
I will show more detailed pics when I get both of them installed and document the process. But for right now it is just mocked up.
Last edited by CatManD3W; 01-12-17 at 11:43 AM.
01-13-17, 08:51 AM
#902
Went into the dash and heater core last night....wasnt really to bad....Going to start on clearing out the wiring with stuff I dont need anyway.
Heater Core is gone.....Need to come up with something to block off the 2 holes left in the firewall from it.
Heater Core is gone.....Need to come up with something to block off the 2 holes left in the firewall from it.
.
02-01-17, 10:53 AM
#907
Officially placed order today for Tremec t56 Magnum and shifter relocation. I opted to go with American Powertrain for the order.
Only part is the transmission is on backorder....and they will not be arriving for shipment until end of February or Early March.....
Only part is the transmission is on backorder....and they will not be arriving for shipment until end of February or Early March.....
03-06-17, 02:38 PM
#914
Finished off a few items from the "to do" list over this past week.
Since removal of the heater core it left the exposed holes in the firewall that needed to be covered. I ended up using the original pieces as a template and fabricated some new pieces out of aluminum and attached them using seam sealer.
I wanted to re-purpose the center vent trim to fit my gauges in and here is the design I came up with. Also shaved the passenger side vent as well. I reused my existing innovate air/fuel and boost gauges and added water temp/voltage and oil press gauge. All gauges are innovate motorsports.
Since removal of the heater core it left the exposed holes in the firewall that needed to be covered. I ended up using the original pieces as a template and fabricated some new pieces out of aluminum and attached them using seam sealer.
I wanted to re-purpose the center vent trim to fit my gauges in and here is the design I came up with. Also shaved the passenger side vent as well. I reused my existing innovate air/fuel and boost gauges and added water temp/voltage and oil press gauge. All gauges are innovate motorsports.
