djrabbi

iTrader: (2)

Do you know what size your original center cap is? I am having a similar issue but getting 2.75 on my center cap but when I run the part number says 2.5

JWBlakk

I measured the flat surface part of my caps where the decals are sitting on and it measured out to be 65mm (2.5"). The best advice I could give is to measure the flat surface of the cap that will have the decals on it and order that size. The part number size could have to do with many other things...i.e. lip of the cap, inside of cap where it clips or even the wheel center hole size which is not the same as the surface you are putting the caps on. Nothing beats a physical measurement...then you know for sure what size to get!!! In the picture below you'll see that my caps had a little lip so I just measured the flat part inside that outer lip and ordered that size.

k0kong

JW,
Thank you for posting this, I have a set of Niche wheels and was dying to come up with something to cover the center cap with. Can't wait to see how they look on my car now once they arrive!

JWBlakk

Nice! Yeah the original Niche center caps were boring as hell haha. Post pics once you get it all squared away...can't wait to see!!!

markdav801

Wow, can’t find these anymore on eBay!

bendevious

I have these on my wheels and they don't stick very well. I have lost two already. Just ordered another set. Open to any ideas on how to get them to adhere better? Gorilla Glue?

JWBlakk

This was a few years ago so I don’t know anymore. I have an NX now and put 20” Lexus RX F Sport wheels on it so I have actual Lexus center caps now lol.

JWBlakk

I would try 3M VHB tape. Use alcohol to prep and an adhesive primer prior to applying. Also add some heat and press to bond it better. I used it and did this for my current spoiler on my NX and it hasn’t budged at all in 2.5 years!

markdav801

Noted. Question, do they fade?

np20412

I ordered the cheapest ones I could find on Amazon (not available anymore apparently) and they are on tight on my wheels. The key is prepping the surface really well. If that fails, vhb will make sure they don't come off, lol.

These look the same, though: https://natalexauto.com/products/4pcs-65mm-lexus-logo-wheel-center-sticker-black?currency=USD&variant=32551716159559&utm_medium=cpc&utm_source=google&utm_campaign=Google%20Shopping&utm_campaign=gs-2020-09-03&utm_source=google&utm_medium=smart_campaign&gclid=CjwKCAjw7fuJBhBdEiwA2lLMYZaa0mgTACE4D6HBSqkhqhbGvAz9eGkJ1_zrixjjEHzxv1qZaW1tTRoCNLwQAvD_BwE

JWBlakk

I only had the wheels another few months after this and they didn’t fade at the time.

peasodos

iTrader: (1)

I like the OEM Plus look of your wheel and center cap combination. Whoops just realized how old this thread is, but good job.