CCS-P Aero Installation instructions
The following users liked this post:
FNSSESPORT (05-27-17)
#21
Part 1 of 3
Ok, so i got the rear diffuser installed. I was under the impression it would just mount up to factory points and there would be no drilling or modifications required. I was slightly wrong. Maybe USDM/Canadian cars are spec'd different than JDM/EDM cars, or maybe this is just the way it is. Mind you, the modification and drilling required was SUPER minor. you just have to notch and drill the rear bumper, then drill the rear under tray.
Notched and drilled the bumper
Placed clips
Installed!
There was a gap where the center of the diffuser met the bumper, but the 3M tape fixed that.
Notched and drilled the bumper
Placed clips
Installed!
There was a gap where the center of the diffuser met the bumper, but the 3M tape fixed that.
The following users liked this post:
n9tkd9 (03-26-20)
The following users liked this post:
FNSSESPORT (05-28-17)
The following users liked this post:
FNSSESPORT (05-28-17)
#25
It's going to look amazing. I have a few members on my page on Facebook with the CCSP parts. All in Japan or Australia. Good stuff. Congrats on picking these up . These are parts that F fanatics will appreciate.
The following users liked this post:
FNSSESPORT (05-28-17)
#26
#27
Installed Parts 2 of 3 today - Front Splitters
Installed the front splitters today. I had the TOMS before these, which I really liked and will miss. But I do like how these splitters play into the IS-F "fangs"
Ignore the previous scars from my TOMS.
Ignore the previous scars from my TOMS.