Home Car Lift
#1
Advanced
Thread Starter
Home Car Lift
Any of you have one you can recommend? Been thinking about ordering one so I can change up wheel sets and do my own oil changes. Something similar to this...
#5
Advanced
Thread Starter
#6
Driver School Candidate
http://www.gtrlife.com/forums/topic/.../?hl=quickjack
I started this thread a while back before I started working on my gtr at home and have done anything and everything using the quickjack. checkout the thread and there are some other ideas from folks on there as well for heavier cars like ours. Hope it helps
I started this thread a while back before I started working on my gtr at home and have done anything and everything using the quickjack. checkout the thread and there are some other ideas from folks on there as well for heavier cars like ours. Hope it helps
The following users liked this post:
Carnevino (08-01-17)
#7
I use these at the shop, considering getting one for myself. It has no issue lifting 5400lb Land Rovers.
https://www.napaonline.com/en/p/FWD6000MRLFBK
They even roll around on the pump dolly, if you're feeling determined It's a smooth half ton, although rolling is more like 500lbs.
https://www.napaonline.com/en/p/FWD6000MRLFBK
They even roll around on the pump dolly, if you're feeling determined It's a smooth half ton, although rolling is more like 500lbs.
Last edited by Suburbazin; 08-01-17 at 05:59 PM.
Trending Topics
#8
Driver School Candidate
I was checking this one out as well due to my wife's escallade but chose the other one as all these scissor ones either hinder the ability to access or work on exhaust pieces especially on track. Obviously this would easily serve the OP purpose if he was not working on the underneath of the car.
I use these at the shop, considering getting one for myself. It has no issue lifting 5400lb Land Rovers.
https://www.napaonline.com/en/p/FWD6000MRLFBK
They even roll around on the pump dolly, if you're feeling determined It's a smooth half ton, although rolling is more like 500lbs.
https://www.napaonline.com/en/p/FWD6000MRLFBK
They even roll around on the pump dolly, if you're feeling determined It's a smooth half ton, although rolling is more like 500lbs.
#9
Forum Administrator
iTrader: (2)
Couple of options in this thread https://www.clublexus.com/forums/sc4...-car-lift.html including one we have for my wife's track car( ez-lift) which is down fairly low in this pic. Uses a power drill to raise and lower
Attached thumbnail shows from underneath (ignore the wheel and front bumper)
Attached thumbnail shows from underneath (ignore the wheel and front bumper)
Last edited by DaveGS4; 08-01-17 at 08:21 PM.
The following users liked this post:
Carnevino (08-02-17)
#11
Forum Administrator
iTrader: (2)
Thread
Thread Starter
Forum
Replies
Last Post