havok123

Ok im doing the lower control arm bushings on my 92 SC400. I had to cut the back two camber bolts out cuz they were not coming out. The steel sleeve that you need to reuse for the prothane kit is junk.

If someone could give me the dimensions for them i could make at school or work. Or if someone had 2 extra that would be great. I need to have the car done soon. Any help is apresiated!

Thanks
-Mike

havok123

bump

anyone?

sc250tt

Im having the same problem .The bolt is stuck on the sleve wont move for nothing. What did you end up doing?

UpInTheLex

iTrader: (5)

BP blaster and a torch. Get the bolt HOT! and use a Plastic deadblow hammer to knock it out of there without damaging the threads.

havok123

went out and boguht new lca's and all new hardwear. Was the only option i had tried for 2 days to get the bolts out.