TRD front tower bar
#1
TRD front tower bar
Coming to find out today that putting the TRD front tower bar with spacer (*which i waited a month from carson*)on my 2jz-ge does not fit.... what it does it hit the throttle which will NOT full engage when u try to step on the gas.... i just wanted to point that out to everyone so they dont need to waste there time...
-dUck
-dUck
#2
Absolute hogwash! I have the front TRD STB on my SC as well and mine fits just fine...Although, I gotta admit that it's been a bit of a "balancing act" All you really need are 2 pairs of spacers (Which I got from a local junkyard) a couple of washers (For the passenger's side) and you need to remove your Throttle Positioning Sensor (TPS) shield...After all that installation process is complete, Your TRD STB shouldn't even be hitting the intake manifold and should have at least half an inch of clearance...It should only be hitting the intake manifold when you turn really hard. (Which is only brief anyways, LOL!).
Last edited by CrazySC300; 10-04-08 at 12:19 AM. Reason: 4 got some details.
#5
thats what i have been saying. the shear force is applied to the bolts is not good either. so far the only one i have seen that actually works well is the carbing. it also has a built in master cylinder stopper.
Trending Topics
#11
http://www.tein.com/carbing/index.html
it says in development but i have seen some around
heres a pic i found......
it says in development but i have seen some around
heres a pic i found......
Last edited by YeA 2jZ; 11-13-08 at 06:26 PM. Reason: add pic
Thread
Thread Starter
Forum
Replies
Last Post