VJZ

iTrader: (3)

I cannot get the rotors off the front of the car.

I have tried beating the **** out of them with a hammer.


I have tried using bolts in the holes.

I have tried a pry bar.




NOTHING I can think of will get these rotors off.


And I have never, ever had this big of a deal in getting rotors off of a car.

Any other ideas?

cssnms

Try dousing it with WD-40 and let it sit for a little while then have a go at it again.

TheMole

iTrader: (13)

Do they still have those small philips screws holding it onto the hub? If not, I would spray some pb blaster or wd40 as mentioned above. I just kept hitting the rotor in multiple spots with a hammer.

GSteg

iTrader: (15)

usually the bolt method works. Are you using the right size nut?

I'd use PB blaster before using WD40.

VJZ

iTrader: (3)

I got it!


I called Billy Mays. He came over with some Mighty Putty and took care of it for me.

Optimus Prime couldn't pull that apart!!


No, but seriously, I ended up hitting it for about an hour a side, and then finally got enough rust loose to get a bolt in the pop holes.

Lucas synthetic red grease works MIRACLES on that stuff.



Oh....and I'll be getting Supra brakes within a few months.


Anyone know where I can just get ONLY the brackets for them?