Whoooo hoooo (LS400 Calipers)
#48
Lexus Test Driver
Thread Starter
Finally installed.
Well, I installed all the rotors and the brake lines last night but could not finish so I left them on stands and finished the next day. Fresh fluid on the lines too
Here are some pictures. I did have to grind the caliper a bit for the lower bolt to line up properly.
Here are some pictures. I did have to grind the caliper a bit for the lower bolt to line up properly.
#52
Lexus Test Driver
Thread Starter
Norwalk, CA... Bleeder kit kinda has a leak. I taped it up with teflon (temporarily) but still leaking. I need to cut the hose and change it.... But really tho, sorry i can't. I don't like tools leaving my garage. I usually have friends over for them to work on their cars tho and they chip in a few change for borrowing my tools
#53
Driver
iTrader: (1)
Join Date: Oct 2008
Location: ca
Posts: 199
Likes: 0
Received 0 Likes
on
0 Posts
its all good. norwalk is a little far for me. im in fresno, ca. i'll post my pics up when im done as well. front tt set up only cost me $341! calipers($186 via napa) rotors and pads($155 via autozone). i almost sharted myself when i discovered this. by the way, are you runing the technafit ss brake lines or goodridge?
#54
Lexus Test Driver
Thread Starter
Technafit...... it sucks tho.. It is the exact same lenght but they should have made it at least an inch longer since it does not stretch... I'll get one made when I get a chance.
#55
Lexus Test Driver
Thread Starter
Got some request of how much my caliper cleared my wheels so I decided to take some pix showing so.
Wheel spec
20x8.5 +40 offset (no spacers). Got lucky it cleared my 98 LS400 calipers. Haven't had any problem with it. I have taken some sharp turns and have taken the car as fast as about 120MPH (don't want to push it really. It was a one maybe a couple of time thing LoL).
Here are some pix. Enjoy (cleared the calipers by almost 3mm as you can see in the picture)
Wheel spec
20x8.5 +40 offset (no spacers). Got lucky it cleared my 98 LS400 calipers. Haven't had any problem with it. I have taken some sharp turns and have taken the car as fast as about 120MPH (don't want to push it really. It was a one maybe a couple of time thing LoL).
Here are some pix. Enjoy (cleared the calipers by almost 3mm as you can see in the picture)
#56
1JZ Single SC400
iTrader: (59)
Join Date: Jan 2009
Location: Alabama, Roll Tide!
Posts: 8,518
Likes: 0
Received 15 Likes
on
12 Posts
You are the bomb! Thats exactly what I needed to see. Thanks alot for doing this. Now on with my project. Can anyone tell me how much of the caliper I can shave, if any, to help me clear my aftermarket rims?
Thread
Thread Starter
Forum
Replies
Last Post
jwynn
LS460 / 430 / 400 / 600h Classifieds
0
05-17-16 02:34 PM
dwebb99
SC400 / 300 Classifieds
4
02-20-12 06:18 PM