New style EBC slotted rotors...thoughts???
#31
I wanted to wait until after the break-in period was over to do a complete review of the setup...
EBC is recommending 1000 miles to allow for proper break-in, and I have only put about 250 miles on them...so far so good, lots of noise after initial install, but I waited until the cross marks were worn off the rotors and did a bedding process and the noise has now stopped...
great feeling from the setup without any wind noise, and yes, the looks are a nice added bonus...very happy so far :grinning:
EBC is recommending 1000 miles to allow for proper break-in, and I have only put about 250 miles on them...so far so good, lots of noise after initial install, but I waited until the cross marks were worn off the rotors and did a bedding process and the noise has now stopped...
great feeling from the setup without any wind noise, and yes, the looks are a nice added bonus...very happy so far :grinning:
#32
When I get home I will post the actual "race" bed in process EBC put into the brake pad box, online they only post the "street" process...the difference is that you may have to perform 2 bed ins, one after the intial wear and one after about 1000 miles or so...
Thread
Thread Starter
Forum
Replies
Last Post