Slight Vibration at idle after BC Coil install
#16
Probably from the use of the top plates since there metal with no sort of rubber bushing like the stock units. This will help with road feedback but you probably will feel more vibration because of this.
Alignment should not have anything to do with this but you do need to get it aligned asap since i'm sure your toe and camber are off.
Alignment should not have anything to do with this but you do need to get it aligned asap since i'm sure your toe and camber are off.
Sorry if this is a dumb question, but i've never seen the tops of the stock units.
Metal on metal could be the culprit.
#17
Lead Lap
iTrader: (4)
Join Date: Aug 2010
Location: NY
Posts: 429
Likes: 0
Received 0 Likes
on
0 Posts
Cannot reuse the stock tops. Its very likely you will get vibration because of the metal tops. I do actually think BC sells rubber bushings that can be used with there top hats. I'm not 100% on this but I thought they did.
Thread
Thread Starter
Forum
Replies
Last Post
lexasgs400
GS - 3rd Gen (2006-2011)
8
09-10-10 12:01 PM
Sarorn
Suspension and Brakes
1
02-20-10 01:57 PM