spc front/megan rear
#1
spc front/megan rear
ok so i just returned from iraq and i would like to attack this project this weekend.
the front: i know i need to shave a little off the upper control arm i seen the thread about it.
but for the rears, what exactly does it take to replace? is there a DIY? ive searched but i might just be a bit we-todd-ed lol jk any help would be greatly appreciated.
ill be doing this on base at the craftshop so all tools will be handy or should be lol
the front: i know i need to shave a little off the upper control arm i seen the thread about it.
but for the rears, what exactly does it take to replace? is there a DIY? ive searched but i might just be a bit we-todd-ed lol jk any help would be greatly appreciated.
ill be doing this on base at the craftshop so all tools will be handy or should be lol
#2
Lexus Test Driver
iTrader: (10)
I'm guessing you're talking about the megan rear camber kit? There's a few rear arms that Megan makes, the most popular being the camber arms. It's pretty simple; just a couple bolts. However, I'd an alignment shop deal with setting it to spec. My friend and I tried to eyeball it, and when I took it to the alignment shop, my initial reading was -.5 left, and -1.8 right. Within specs(-.5 to -2.0), but as you can see, not very precise.
Overall time: about 30-45 minutes if you kind of know what you're doing. All we used were couple wrenches, a ratchet and socket set, and a hammer.
Overall time: about 30-45 minutes if you kind of know what you're doing. All we used were couple wrenches, a ratchet and socket set, and a hammer.
Thread
Thread Starter
Forum
Replies
Last Post
aaronqn
3Gen GS460 / 450H / 430 / 350 / 300 Classifieds (06-12)
3
02-16-16 09:20 AM
chuckdaddy
3Gen GS460 / 450H / 430 / 350 / 300 Classifieds (06-12)
4
04-11-11 08:28 PM