firegoose

I'm trying to remove my left rear wheel bearing from my 92 SC300 and can't for the life of me figure out how to get the hub out. I've disconnected all the things I was told to and the hub refuses to come free. Any suggestions would be greatly appreciated.

chnk

iTrader: (12)

wd40 and a rubber hammer, might be rusted on

firegoose

ive tried those but with pb blaster with no results :/ the cup looking thing behind the dust shield looks to be the problem but i cant see a way of removing it

k7q

iTrader: (37)

the cup thing? the axle?

OG Dada

iTrader: (10)

If you're talking about how to remove from the axle, try using a slide hammer. That should do the trick.

k7q

iTrader: (37)

careful not to damage the threads on the axle.

ArodDaLob

iTrader: (14)

I just loosened the 32mm or whatever axle nut and slammed on it via a metal mallet and a pipe that was a tiny bit thinner than the portion of the axle that was popping out of the hub. Slid out after a couple good swings.

firegoose

i got it thanks for the help homies