Cheap way out?
#2
1JZ Single SC400
iTrader: (59)
Join Date: Jan 2009
Location: Alabama, Roll Tide!
Posts: 8,518
Likes: 0
Received 15 Likes
on
12 Posts
Buy the bushings and deal with burning them out on your own. Time consuming but doable. I have done them on three SC's. Way cheaper than new control arms buy far.. .JMO
#4
I have 1992 sc400, if you have the time to have the car out of service for some time in case you run into some difficulty then buying the bushings, for a few $100 dollars is the way to go...now if you want to take a few hrs in one day then go to ebay and buy the lower control arms (left and right) for around $700 both. I did not have the time so I bought the control arms and installed them in about 4 hrs, I did take my time since it was the first time doing it. Good luck with your project.
#5
Lexus Champion
iTrader: (10)
You can do one side at a time for roughly 4 hours each side if you do the bushings route, which, IMO, would also add performance in your suspension. And a set comes for the entire front suspension, meaning upper and lower control arms, every single bushings those 2 have.
#6
also would make your ride hella lot softer for sure, we changed out our entire front end on our 03 matrix (RIP) when we had it...all i gotta say was :O lol yes even my dads mechanic stated it drove like a new car and just glided over the bumps in the rd lol
Thread
Thread Starter
Forum
Replies
Last Post
IRRELEVANT
Suspension and Brakes
6
08-19-11 07:45 AM