Show me your Ls400 brake setup
#47
Pole Position
Thread Starter
iTrader: (4)
Join Date: May 2010
Location: CA
Posts: 268
Likes: 0
Received 0 Likes
on
0 Posts
hello, im about to replace my stock seized up calipers with LS400, WHAT YEARS are preferred?
I work at the warehouse associated with junk yard so i get access to all kind of parts and info, the reason im asking is because LS400 calipers fit only 91-92, 93-94, and 95-00 (at least according to my system)
What year should i get and what should i be looking for?
Thank you
I work at the warehouse associated with junk yard so i get access to all kind of parts and info, the reason im asking is because LS400 calipers fit only 91-92, 93-94, and 95-00 (at least according to my system)
What year should i get and what should i be looking for?
Thank you
#48
Driver School Candidate
Thank you.
I got '95 LS400 Brakes with almost new brake pads and was all excited until i start cleaning them up. I used wire wheel and it was working wonders even when it slipped and went over my hand. I decided to clean inside of them too and noticed one boot worn off and cylinders rusted. By the way the white stuff is De-Ruster also works great. Im in little trouble now, i read that everyone used air to get cylinders out, but i dont have air at all, so is there another way to get cylinders out?
Here are few pictures:
I got '95 LS400 Brakes with almost new brake pads and was all excited until i start cleaning them up. I used wire wheel and it was working wonders even when it slipped and went over my hand. I decided to clean inside of them too and noticed one boot worn off and cylinders rusted. By the way the white stuff is De-Ruster also works great. Im in little trouble now, i read that everyone used air to get cylinders out, but i dont have air at all, so is there another way to get cylinders out?
Here are few pictures: