mecheng10

So i just did the ls400 brake swap on my 93 sc300.
but the banjo bolts are leaking profusely, so im just making a mess everywhere.
I used new crush washers on both sides, didnt help.
Do i need to get ls400 brake lines?
Any suggestions?

SexCoupe

iTrader: (6)

check to make sure the surface of the calipers where the washers meets touches the caliper is flat if thats not the problem it is the banjo bolts...was it hard or easy to screw in?

mecheng10

it was super hard to screw in.

SexCoupe

iTrader: (6)

you need LS banjo bolts then you dont need the lines....they should tighten all the way down with fingers then a few turns of the ratchet

mecheng10

what is the part number for a ls400 banjo bolt?
Or what is the size?

What is the difference between the sc300 and ls400 banjo bolts?