AWD is250 stock camber adjustment?
01-16-15, 10:59 AM
#1
AWD is250 stock camber adjustment?
So I was browsing thru some threads about camber adjustments on our 2is's and came across a user comment which stated that a stock suspension on an AWD is250 has camber flexibility and capabilities up front? If this is true, then I can resell my SPC balljoints which were purchased with the intent of correcting camber a bit after a 2.25" drop.
I currently have all the alignment pieces I need but I don't actually have the coils yet.... guess I purchased stuff in the wrong order. (Funds are low at the moment so I'm waiting to cop a set of BC's)
I currently have all the alignment pieces I need but I don't actually have the coils yet.... guess I purchased stuff in the wrong order. (Funds are low at the moment so I'm waiting to cop a set of BC's)
01-20-15, 07:51 AM
#2
Thanks to Jeff Lange, a forum moderator for the info... guess I might end up selling my ball joints!
No problem.
For further information, see the front suspension diagram and repair manual instructions for adjusting camber on AWD models:
Jeff
Originally Posted by Jeff Lange
Originally Posted by Nixcision
hmmm very few people seem to know this on the forum!
Glad I heard about this though. I was under the impression that camber could not be adjusted on any stock suspension of any 2is
Anish
Glad I heard about this though. I was under the impression that camber could not be adjusted on any stock suspension of any 2is
Anish
For further information, see the front suspension diagram and repair manual instructions for adjusting camber on AWD models:
Jeff
Thread
Thread Starter
Forum
Replies
Last Post