Bent bolt
#2
Buy a new bolt, cut the hex head off, and hammer towards the front of the car (if the inside is still straight, then it should come out.
If it's only bent on the threaded side, then cut that end off and hammer out the way its supposed to go.
If it's only bent on the threaded side, then cut that end off and hammer out the way its supposed to go.
The following users liked this post:
AuntPearl (12-16-17)
The following users liked this post:
AuntPearl (12-16-17)
Thread
Thread Starter
Forum
Replies
Last Post