Tanabe NF210 with Works Wheels
#1
Driver School Candidate
Thread Starter
Tanabe NF210 with Works Wheels
Works Zeast ST2 polish lips with brushed centers
Japan specs 20 x 8.5 40 and 20 x 9.5 47
235/35 and 275/30
Last edited by coupe1; 01-03-16 at 04:13 AM. Reason: More photos
#3
Driver School Candidate
Thread Starter
The NF210 springs felt very good when I had them on my OEM 18s. But obviously with the 20s the suspension
Is harder and bumpier. Looks wise it's outstanding. Just right
Is harder and bumpier. Looks wise it's outstanding. Just right
#6
Looks real good man!
Trending Topics
#8
Driver School Candidate
Thread Starter
Yes I am on Tanabe NF210 springs.
To answer an earlier post, I did not get more concave rear wheels because that meant a lower offset and I wanted
My car to be drivable and with handling specs closer to OEM. Our aftermarket wheel widths here tend to be narrower than the USA. My wheel widths were recommended by Works Japan and taken off their website guide. They are conservative when compared to the 9.5 / 10.5 widths normally used there
To answer an earlier post, I did not get more concave rear wheels because that meant a lower offset and I wanted
My car to be drivable and with handling specs closer to OEM. Our aftermarket wheel widths here tend to be narrower than the USA. My wheel widths were recommended by Works Japan and taken off their website guide. They are conservative when compared to the 9.5 / 10.5 widths normally used there
Thread
Thread Starter
Forum
Replies
Last Post