FS: LS430 Fitment I-Forged 20x10 20x8.5 lots of pics
#1
Driver
Thread Starter
Join Date: May 2002
Location: Fremont, CA
Posts: 126
Likes: 0
Received 0 Likes
on
0 Posts
FS: LS430 Fitment I-Forged 20x10 20x8.5 lots of pics
SOLD!!!
I just sold my LS430 and the wheels are now up for sale. They are fully polished (inside barrels are polished also) I-Forged Retros. The size is 20x8.5 and 20x10, I purchased these from Vince at I-Forged in late 2004. Also these where made to clear a StopTech 14" 4 wheel bbk.
There is NO curb rash! Hub centric rings and lug nuts included.
The tires are no good and need to be replaced. I bent two inside barrels on the wheels going 680S by Milpitas, they where repaired by Wheel Techniques. After the repair I always noticed a vibration and Wheel Tech told me the bead on the two tires where damaged and that was causing the vibration. Not feeling the vibration was worthy of a new set of tires I continued to drive on them until the car was sold.
They might fit other models but not sure which.
I am located in Fremont and prefer pick up only.
AS-IS $2000
Thanks
Mike
I just sold my LS430 and the wheels are now up for sale. They are fully polished (inside barrels are polished also) I-Forged Retros. The size is 20x8.5 and 20x10, I purchased these from Vince at I-Forged in late 2004. Also these where made to clear a StopTech 14" 4 wheel bbk.
There is NO curb rash! Hub centric rings and lug nuts included.
The tires are no good and need to be replaced. I bent two inside barrels on the wheels going 680S by Milpitas, they where repaired by Wheel Techniques. After the repair I always noticed a vibration and Wheel Tech told me the bead on the two tires where damaged and that was causing the vibration. Not feeling the vibration was worthy of a new set of tires I continued to drive on them until the car was sold.
They might fit other models but not sure which.
I am located in Fremont and prefer pick up only.
AS-IS $2000
Thanks
Mike
Last edited by IS Pilot; 09-05-07 at 02:23 PM. Reason: added price
#6
Driver
Thread Starter
Join Date: May 2002
Location: Fremont, CA
Posts: 126
Likes: 0
Received 0 Likes
on
0 Posts
I am not sure about the G35, I know they will bolt up just not sure about being flush with your fender lip.
Also these where made to clear a StopTech 14" 4 wheel bbk.
Also these where made to clear a StopTech 14" 4 wheel bbk.
Trending Topics
Thread
Thread Starter
Forum
Replies
Last Post