When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have a set of staggered (20x8.5 & 20x10) 2-piece iForged Aero wheels wrapped with 245/35/20 and 275/30/20 Sumitomo HTR ZIII tires. Wheels are almost three years new (less than 10k miles) but kept in great condition. The new tires have approximately 500-1000 miles. I'm asking $3500 for the wheels, tires (recently road force balanced), Lexus tires sensors, Continental flat repair kit (mini compressor and 2 sealants), Gorilla wheel locks (20 lug nuts with key and 3/4F x 13/16M hex adapter), iForged water diverter kit, and two sets of hub-centric rings. I have the original receipts for everything! Currently, the wheels/tires are installed on the vehicle. My GS300 is over three years old with 12k miles and always garaged. I'm located in the San Francisco East Bay Area.
anyway without tires? any idea on offset? tires too big for my 2GS... thanks!
I need to sell with the tires. When I contacted iForged they couldn't disclose the offset because it was not specified on the "build sheet". Why would these size tires be too big on a 2GS?
I need to sell with the tires. When I contacted iForged they couldn't disclose the offset because it was not specified on the "build sheet". Why would these size tires be too big on a 2GS?
Tires are too thick in the front... ideally it should be 245-30-20. The extra height might damage front fenders while turning.
Tires are too thick in the front... ideally it should be 245-30-20. The extra height might damage front fenders while turning.
That setup is what IForged specs the wheel to sit flush with the car. It fits fine on a 2GS. I have a set that I run 255/35/20 front and 285/30/20 rear and it doesn't rub at all.
02-13-09, 08:02 PM
FS: 20" iForged Aero Wheels (06 GS)
