When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I do not know exactly. I was told they were "high offset" just for that purpose but I do not have any numbers and iForged does not give you this data. Any other way I can check for you?
I guess the only ways to know if you can get an is350 to fit. Otherwise if you can take a straight edge and put on the hub, then take a ruler and measure the distance from the spoke to hub to see how much clearance we're looking at.
On the second picture you posted its the right way to do it but I'm looking at the measurement from the hub (where the rim meets the rotor part)to the spoke to see brake caliper clearance.
Thanks
ps dont worry about it. Had a local dealer call in iforged and told me they wont fit the IS350. Offsets are higher if they are made for your GS model.
On the second picture you posted its the right way to do it but I'm looking at the measurement from the hub (where the rim meets the rotor part)to the spoke to see brake caliper clearance.
Uhh... those pics tell me that its a little over two inches from the outside of the hub to the back of the spoke. You take the greater measurement and subtract the lesser.
He just didn't have a short enough straight edge to fit inside the wheel.