CA Used Set Of 16" Blitz Type 01's Black Face 5x114.3
#1
Lead Lap
Thread Starter
iTrader: (26)
Join Date: Nov 2006
Location: California
Posts: 438
Likes: 0
Received 0 Likes
on
0 Posts
Used Set Of 16" Blitz Type 01's Black Face 5x114.3
SOLD SOLD SOLD
These are for the Honda and Nissan daily drivers out there. I have a set of 16" Blitz Type 01's 5x114.3. The fronts are 7" and rears 8". The offset is 38 all the way around. Five years ago I re-polished the lips and origanally had the faces powder coated red but I didn't like how they looked so I had the powder coated again in gloss black. The shop I brought them to did not do the best job so they did not charge me. The edge where the black and polished lip meet was not masked off like it should have been done. That's why I am only asking $550. I paid $1100 back then before attempting to refinish them. I do have all the rivets but they need to be cleaned up and polished with some aluminum polish solution. There is a slight bend in one of the front wheels. Hard to even spot but I want the buyer to know every flaw. In the third picture, I can't even find it. The shadow has to hit it perfectly to be noticed. I circled where the bend is. I'm sure it could be fixed very easily. There is no curb rash on any of the wheels. There are scuff marks here and there from me moving them around for the past 5 years they have been sitting in my garage. They should be easily polished out.
These are for the Honda and Nissan daily drivers out there. I have a set of 16" Blitz Type 01's 5x114.3. The fronts are 7" and rears 8". The offset is 38 all the way around. Five years ago I re-polished the lips and origanally had the faces powder coated red but I didn't like how they looked so I had the powder coated again in gloss black. The shop I brought them to did not do the best job so they did not charge me. The edge where the black and polished lip meet was not masked off like it should have been done. That's why I am only asking $550. I paid $1100 back then before attempting to refinish them. I do have all the rivets but they need to be cleaned up and polished with some aluminum polish solution. There is a slight bend in one of the front wheels. Hard to even spot but I want the buyer to know every flaw. In the third picture, I can't even find it. The shadow has to hit it perfectly to be noticed. I circled where the bend is. I'm sure it could be fixed very easily. There is no curb rash on any of the wheels. There are scuff marks here and there from me moving them around for the past 5 years they have been sitting in my garage. They should be easily polished out.
Last edited by 2GSonAir; 10-28-09 at 12:14 PM.
Thread
Thread Starter
Forum
Replies
Last Post
RavSpec
Club Lexus Vendor Marketplace
1
06-07-14 09:26 PM
sniper
General Classifieds
1
06-24-09 10:53 PM