CA FS/FT AME Shallen WX 19" Diamond Cut
02-27-10, 01:34 PM
#16
Lexus Champion
Thread Starter
small scratch on the front drivers wheel,
other side has scratches on the wheel center caps, it looks like someone tried to steal my center caps. These can probably be polished out with some detail work.
tires have about 9/32's.... definitely almost new w/ LOTs of quality tire left in them....
02-27-10, 01:44 PM
#17
Lexus Champion
Thread Starter
rear tire
worst part is minor curb rash on the rear wheels barely visible... these can definitely be sanded and polished back to mint condition. They are really small on the outer edge about a few inches along the diameter.
here you can see, its hardly visible... i drove so the scratch is upward facing and I'm standing about 1.5 ft away from the car
here is the wheel again...
here is the other side, scratch is not visible. It is at the 6 o'clock position
worst part is minor curb rash on the rear wheels barely visible... these can definitely be sanded and polished back to mint condition. They are really small on the outer edge about a few inches along the diameter.
here you can see, its hardly visible... i drove so the scratch is upward facing and I'm standing about 1.5 ft away from the car
here is the wheel again...
here is the other side, scratch is not visible. It is at the 6 o'clock position
Last edited by UptownGS; 02-27-10 at 02:26 PM.
02-28-10, 03:39 PM
#19
Lexus Champion
Thread Starter
03-02-10, 06:47 PM
#23
Lexus Champion
Thread Starter
03-03-10, 01:36 PM
#25
Lexus Champion
Thread Starter
itz_jOw3.... I'm going back to 20's plus already gettin wheels on order. Dude how is the team? haven't seen anyone in so long.... you need to paint your car back to black dude!
03-04-10, 04:30 PM
#28
Lexus Champion
Thread Starter
PM replied! 
These wheels will fit ISX50's looking for aggressive fitment. You will need to do moderate fender work.
SC300-400's should be pretty flush, must shave or roll fenders.
on 2GS's these will give slight poke in the rear and could use a 2 or 3mm up front for perfect flush up front. Shave or roll required.
3GS would look pretty good, shaving would be required.
These wheels will fit ISX50's looking for aggressive fitment. You will need to do moderate fender work.
SC300-400's should be pretty flush, must shave or roll fenders.
on 2GS's these will give slight poke in the rear and could use a 2 or 3mm up front for perfect flush up front. Shave or roll required.
3GS would look pretty good, shaving would be required.
Thread
Thread Starter
Forum
Replies
Last Post
J J
Wheels and Tires Classifieds
9
04-21-11 11:40 AM
anotherLS
Wheels and Tires Classifieds
15
03-14-11 10:54 PM
