03' GS430 Wheel Fitment
06-05-05, 07:46 AM
#16
Lead Lap
Thread Starter
iTrader: (1)
Join Date: Mar 2002
Location: Minnesota
Posts: 456
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by rominl
for the record i am running 8.5 +32 and 10 +43 20s (just like your 19s with fat setup) so there you go. 9.5 +41 isabout 4mm more inboard. i dn't have to trim my rear fenders
Thanks again to everyone for their input, it helps out alot
06-05-05, 06:20 PM
#17
It really depends on how low you go. rominl has 8.5 +32 in front and I have 8.5 +42. Mine is pretty conservative but I still rub.
It mainly rubs on the fender tab when you do full turns and reverse. It also rubs the top of the wheelwell liner if I hit a big enough dip going fast on the freeway. There is already a hole at the top of my liner.
It mainly rubs on the fender tab when you do full turns and reverse. It also rubs the top of the wheelwell liner if I hit a big enough dip going fast on the freeway. There is already a hole at the top of my liner.
Last edited by Neo; 06-06-05 at 03:29 AM.
06-06-05, 03:28 AM
#19
Originally Posted by rominl
imho if you have 19s fat setup or 20s, if you get 8.5 and offset of 38 or higher you wouldn't rub the outside of the fender
06-07-05, 01:27 AM
#22
Originally Posted by Neo
Yup. I may have to bend the tab more but at +42, I did not think it would hit at all.
I may have to bend the tab more but at +42, I did not think it would hit at all.just bend the whole thing up i say
Thread
Thread Starter
Forum
Replies
Last Post
Eggplantgs
GS - 2nd Gen (1998-2005)
8
09-22-17 08:44 PM
