2005 RX 330 aftermarket wheel question
#1
Driver School Candidate
Thread Starter
Join Date: Mar 2016
Location: Ontario
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
2005 RX 330 aftermarket wheel question
Hi all,
Just picked up a 2005 lexus rx330, beautiful 1 owner vehicle, panoramic roof with only 80k.
I have a set of 19" Kahn Cosworth wheels that were on my Infiniti G37 sedan. Expensive set of wheels, shipped in from England 2 years ago.
Rim specs-- 19 x 8.5, 35 offset
Tire - 245 or 255, 50/19
Will these rims for the Rx330?
I did run some numbers on a wheel offset calculator, showing 25.4mm (0.96") closer on inside.
Anyone ever tried fitting 19x8.5 et35 on a rx330 or rx350 2nd Gen?
Last edited by Nas77; 03-25-16 at 08:03 AM.
#2
Pit Crew
If they had same bolt pattern like 5-114.3, then you have to consider the center bore and find the correct hub centric ring.
Too close on inside is easy, H&R wheel spacers can fix that.
I installed 20mm spacer on my 13" RX450h for a few years and never have a problem.
You could use a 25mm to fix that, or 30mm to make it a little bit wider.
Too close on inside is easy, H&R wheel spacers can fix that.
I installed 20mm spacer on my 13" RX450h for a few years and never have a problem.
You could use a 25mm to fix that, or 30mm to make it a little bit wider.
#3
Driver School Candidate
Thread Starter
Join Date: Mar 2016
Location: Ontario
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
If they had same bolt pattern like 5-114.3, then you have to consider the center bore and find the correct hub centric ring.
Too close on inside is easy, H&R wheel spacers can fix that.
I installed 20mm spacer on my 13" RX450h for a few years and never have a problem.
You could use a 25mm to fix that, or 30mm to make it a little bit wider.
Too close on inside is easy, H&R wheel spacers can fix that.
I installed 20mm spacer on my 13" RX450h for a few years and never have a problem.
You could use a 25mm to fix that, or 30mm to make it a little bit wider.
The wheels are 5x114.3 bolt pattern, will need a hub Centric for sure, hub bore is 75mm on the Cosworth wheels. Will be test fitting in the next couple weeks, will update this post for other members.
#4
2005 Rx 330 20" wheels and tires
I am looking to put these wheels and tires in. Need help as if they will fit. The tires are 265/45/20.
And the rim is
9Jx20 ET40.5.
Any help and feedback would be appreciated.
And the rim is
9Jx20 ET40.5.
Any help and feedback would be appreciated.
Thread
Thread Starter
Forum
Replies
Last Post