ClubLexus - Lexus Forum Discussion
It was cool to see that the diagnosis check wire & SST for the crank pulley were still available, both of which will/have come in handy.
It was cool to see that the diagnosis check wire & SST for the crank pulley were still available, both of which will/have come in handy.
0 2020/10/12 20:31:17
Bit overboard buying bulbs from Toyota, but cheap is cheap!
Bit overboard buying bulbs from Toyota, but cheap is cheap!
0 2020/10/12 20:31:44
Can't match that warm
Can't match that warm
0 2020/10/12 20:31:46
New ignition coils
New ignition coils
0 2020/10/12 20:31:49
Last gasket to finish with the hydro fan before adding the new fluids.
Last gasket to finish with the hydro fan before adding the new fluids.
0 2020/10/12 20:31:52
New ECT sensor for the radiator.
New ECT sensor for the radiator.
0 2020/10/12 20:31:54
New radiator hose clamps x4
New radiator hose clamps x4
0 2020/10/12 20:31:57
The failed Denso radiator after the 1st start/coolant bleed, appeared to be an internal leak as seen on either side. May have it repaired in the future.
The failed Denso radiator after the 1st start/coolant bleed, appeared to be an internal leak as seen on either side. May have it repaired in the future.
0 2020/10/12 20:31:59
Original old faithful to go back in, after yet another partial coolant drain..
Original old faithful to go back in, after yet another partial coolant drain..
0 2020/10/12 20:32:02
The day after, coolant bled (again) & ready for a test run.
The day after, coolant bled (again) & ready for a test run.
0 2020/10/12 20:32:04
OEM timing belt service decal put to use!
OEM timing belt service decal put to use!
0 2020/10/12 20:32:07
Pictured above was during the roadworthy inspection. No leaks overnight & test runs went well the day before. Not forgetting to mention that the new wheels/tyres setup didn't disappoint either - straight & true.
Pictured above was during the roadworthy inspection. No leaks overnight & test runs went well the day before. Not forgetting to mention that the new wheels/tyres setup didn't disappoint either - straight & true.
0 2020/10/12 20:32:10
Booked in a couple days later for registration & she's back on the road again. I hadn't washed the car either since purchasing it, as it was pointless while it was off the road accumulating dust & paw prints.. so was great to give the paintwork a good scrub, something it likely hasn't seen in some time!
Booked in a couple days later for registration & she's back on the road again. I hadn't washed the car either since purchasing it, as it was pointless while it was off the road accumulating dust & paw prints.. so was great to give the paintwork a good scrub, something it likely hasn't seen in some time!
0 2020/10/12 20:55:38
This is where it's at right now, it's since undergone a fairly substantial exterior detail & a good going over with the touch-up pen. The bumper bars will need to be replaced for a content outcome, but will suffice for now.
This is where it's at right now, it's since undergone a fairly substantial exterior detail & a good going over with the touch-up pen. The bumper bars will need to be replaced for a content outcome, but will suffice for now.
0 2020/10/12 20:55:41
0 2020/10/12 20:55:43
Driving back home through the city after the inspection. Weather was perfect!
Driving back home through the city after the inspection. Weather was perfect!
0 2020/10/12 20:55:45
Was nice to dust the new (old) plates off & fit them at long last. Also fitted up another set of headlights, which were leak-free. As a bonus someone has de-lined the inner lenses & done a pretty good job of it too. Eventually I will pull apart the original units & reseal.
Was nice to dust the new (old) plates off & fit them at long last. Also fitted up another set of headlights, which were leak-free. As a bonus someone has de-lined the inner lenses & done a pretty good job of it too. Eventually I will pull apart the original units & reseal.
0 2020/10/12 21:00:04
The purifier setup as a whole.
The purifier setup as a whole.
0 2020/10/12 22:01:30
Parcel shelf before.
Parcel shelf before.
0 2020/10/12 22:01:32
Stencil cut-out & holes punched for the screws.
Stencil cut-out & holes punched for the screws.
0 2020/10/12 22:01:34
Parcel shelf after. New speaker cover / vents in place & the old anchor point holes plugged - easy part done.
Parcel shelf after. New speaker cover / vents in place & the old anchor point holes plugged - easy part done.
0 2020/10/12 22:01:36
Foam block removed & amplifier / sub wiring relocated into the trunk.
Foam block removed & amplifier / sub wiring relocated into the trunk.
0 2020/10/12 22:01:38
Sub wiring fed back through another opening through the trunk. You can now see where the blower motor resides where the amp once was. While on the opposite side, the metal lid cover is removed exposing the filter.
Sub wiring fed back through another opening through the trunk. You can now see where the blower motor resides where the amp once was. While on the opposite side, the metal lid cover is removed exposing the filter.
0 2020/10/12 22:01:40
A look at the relocated wiring. I still need to run some wire conduit & mount the amp properly, but otherwise that's the fiddly part done with.
A look at the relocated wiring. I still need to run some wire conduit & mount the amp properly, but otherwise that's the fiddly part done with.
0 2020/10/12 22:01:42
Purifier unit bolted in. The loom is then fed through the cabin & into the passenger side foot-well junction block.
Purifier unit bolted in. The loom is then fed through the cabin & into the passenger side foot-well junction block.
0 2020/10/12 22:01:44
Finally filling the last blank cover with the control dial. The connector for it, in a Soarer at least, is tucked away to the side. Got to love the plug & play.
Finally filling the last blank cover with the control dial. The connector for it, in a Soarer at least, is tucked away to the side. Got to love the plug & play.
0 2020/10/12 22:01:46
The end result. Other than purifying the cabin of unwanted smells etc. with the blower motor on & set to the lo setting it creates a somewhat soothing white noise when the audio or climate fan is off.
The end result. Other than purifying the cabin of unwanted smells etc. with the blower motor on & set to the lo setting it creates a somewhat soothing white noise when the audio or climate fan is off.
0 2020/10/12 22:01:48
Loom fed through the cabin & into the unused connector in the passenger foot-well junction block
Loom fed through the cabin & into the unused connector in the passenger foot-well junction block
0 2020/10/12 22:49:55
Connector for the air purifier switch, which is tucked away usual
Connector for the air purifier switch, which is tucked away usual
0 2020/10/12 22:49:57
0 2020/10/12 22:49:59
0 2020/10/12 22:50:01
0 2020/10/12 22:50:04
0 2020/10/12 22:50:06
0 2020/10/12 22:50:08
Parcel shelf before. Stencils for the vents as seen.
Parcel shelf before. Stencils for the vents as seen.
0 2020/10/12 23:04:36
Loom fed through the cabin & into the junction block in the passenger side footwell (white top connector).
Loom fed through the cabin & into the junction block in the passenger side footwell (white top connector).
0 2020/10/12 23:09:52
Connector for the switch, can be found tucked away to the side, in the Soarer at least.
Connector for the switch, can be found tucked away to the side, in the Soarer at least.
0 2020/10/12 23:11:37
0 2020/10/12 23:13:12
0 2020/12/09 15:15:52
0 2020/12/09 15:15:55